Rough Country 328S - Manual (Page 8)

26. Install passenger
side diff bracket using stock hardware in upper location if motor mount is threaded . If not use sup-
plied 12mm x 65mm bolts for top and bottom of pass diff side.
See Photo 25.
27. Tighten all diff bolts at this time using wrenches 15mm for upper diff bracket and 18 an 19mm for all other diff bolts.
28. Apply thread lock to supplied 12mm x 45mm bolts and install driveshaft spacer. Use a 19mm wrench to tighten.
See
Photo 26.
29. Pull down on vent hose for slack and reconnect.
See Photo 27.
30. Follow the diff wire upper to a second connector and undo the clip holding it to the engine wiring harness and pull
down until you have slack to plug in diff connector.
See Photo 28. On 4.7 engines pull clip off of valve cover bolt be-
hind power steering pump to gain slack. Be sure wire is not near exhaust.
31. Install rear cross member using supplied 18mm x 150mm bolts, square washers and nuts.
See Photo 29.
32. Install front cross member using supplied 18mm x 150mm bolts, square washers and nuts.
See Photo 30. Do not
tighten at this time.
PHOTO 25 PHOTO 26
PHOTO 27 PHOTO 28
PHOTO 29 PHOTO 30
INSTALL PAS DIFF IN BRACKET INSTALL DRIVESHAFT SPACER
REINSTALL DIFF VENT HOSE EXTEND WIRING HARDNESS
INSTALL REAR CROSSMEMBER INSTALL FRONT CROSSMEMBER