Rough Country 328S User Manual

Page 7

21. Align the supplied template with the lower holes. Tape cut out to driver side lower control arm rear pocket.
22. Cut at the line on the cut out. this is done to make room for rear cross member. Grind sharp edges and paint.

See

Photo 19 & 20.

23. Install rear diff drop brackets using 3 supplied 12mm x 45mm bolts, washers.

See Photo 21. Do not tighten at this

time.

24. Install upper diff drop bracket using 2 of the stock driveshaft bolts.

See Photo 22.Do this only if the motor mount /

diff mount is threaded. If not threaded use stock hardware removed from diff / engine mount. Do not tighten at this
time.

25. Install diff in both drop brackets as shown in

Photo 23 & 24 using supplied 12mm x 65mm bolts, washers and nuts.

Do not tighten at this time.

PHOTO 19

PHOTO 20

PHOTO 21

PHOTO 22

PHOTO 23

PHOTO 24

CUT USING A RECIPROCATING SAW

INSTALL DIFF BRACKET

REINSTALL DIFF ON BRACKET