Rough Country 328S - Manual (Page 6)

16. Remove the two upper diff bolts from the motor mount / diff mount using 18mm socket. These bolt can be very hard
to access. Also the diff mount may be threaded or nuts may be present depending on engine size and year model.
Retain the stock hardware if nuts are present. Use 15mm and 18mm wrench to remove hardware from motor
mount /engine mount when nuts are present. If mount is threaded the hardware will
not be retained. See Photo 14.
17. Remove rear cross-member using 18mm wrench.
See Photo 15.
18. Remove driveshaft from diff using 15mm wrench.
See
Photo 16.
19. Support the diff and remove the passenger side bolts with
18mm and/or 15mm wrench and remove the 3 bolts on
driver side with same wrenches.
See Photo 17 & 18.
20. Carefully remove differential from vehicle.
PHOTO 14 PHOTO 15
PHOTO 16
PHOTO 17 PHOTO 18
REMOVE THE UPPER MOUNT HARDWARE REMOVE THE REAR CROSSMEMBER
REMOVE THE DRIVESHAFT BOLTS
REMOVE PASSENGER SIDE HARDWARE REMOVE THE DR SIDE DIFF HARDWARE