Rough Country 328S User Manual
Page 14
8. Remove upper track bar bolt using 21mm wrench.
See Photo 7.
9. Remove the vent hose from axle.
10. Remove coil springs.
See Photo 8.
11. Install the flat upper spacer retainer as shown in
Photo 9 on the upper coil seat.
12. Install the spring spacer and secure with the supplied 3/8
” x 3 1/2” bolt through the upper flat retainer to hold the
spacer in place. Tighten using a 14mm Socket & wrench.
See Photo 10.
13. Install bump stops using supplied 3/8
” x 1” bolts, washers and nuts. The dow pin in the block goes in front hole as
shown in
Photo 11. Tighten hardware using a 14 mm wrench.
14. Install coil spring with stock isolator.
See Photo 12.
PHOTO 7
PHOTO 8
PHOTO 9
PHOTO 10
PHOTO 11
PHOTO 12
See also other documents in the category Rough Country For the car:
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)