Rough Country 7503 - Manual (Page 5)

24. Install the caliper bracket on the spindle. See Photo 19.
25. Install the brake pads and the brake caliper reusing factory bolts. See Photo 20. Torque to factory specs.
26. Install the tire / wheel and torque to factory specs.
27. If shock absorbers were purchased, install at this time with factory hardware.
28. Repeat on drivers side.
29. Jack up front of the truck, remove the jack stands and lower the truck on the ground. Cycle the steering right to left
lock to lock checking for clearance of all components.
30. Vehicle will need to be aligned.
PHOTO 19 PHOTO 20
REAR BLOCK INSTALLATION (IF PURCHASED)
1. Support rear of vehicle with jack stands under the frame rail.
2. Remove the factory u-bolts.
3. With a floor jack, raise rear of vehicle until spring has cleared spring pad enough to install spacer blocks. In the case
of the vehicle having a factory block with a bump stop included on the block, and if the factory block is re-
used; the new block will install on the bottom of the factory block.
4. Install new spacer blocks on spring pad aligning pin with hole in spring pad. (Short side of block goes towards front
of vehicle, if block has taper).
5. Lower vehicle slowly until spring contacts spacer blocks insuring that pin on bottom of spring aligns with center hole
in spacer block.
6. Install new u-bolts and hardware. Tighten u-bolts, alternating from bolt to bolt to 87 ft. /lbs
7. Lower vehicle and install shocks ,if purchased, with factory hardware.