Rough Country 257.20 - Manual (Page 19)

PHOTO 19
INSTALL THE 14MM X 60MM BOLTS
POST INSTALLATION INSTRUCTIONS
1. Check all fasteners for proper torque. Check to ensure for adequate clearance between all rotating, mobile, fixed,
and heated members. Test and inspect brake system.
2. On some vehicles the front lower skirting will need to be trimmed if using certain wheel /tire combinations and with
heavy offset wheels. Trim only as needed.
3. Activate four wheel drive system and check front hubs for engagement.
4. Perform head light check and adjustment to proper settings.
5. All kit components must be retightened at 500 miles and then every three thousand miles after installation. Periodi-
cally check all hardware for tightness.
6. Install “Warning to Driver” decal on sun visor.
13. Reinstall the factory bolts in the newly drilled holes in the frame. Do not tighten at this time. .
14. Reinstall the bumper on the mounts and install the supplied 14mm x 60mm bolts in the hitch as shown in Photo 18.
Do not tighten at this time.
15. Install the 1” tall body pucks as shown above the frame, under the rear bumper mounts to move the bumper up. Se-
cure with the supplied 14mm x 60mm bolts. Do not tighten at this time. See Photo 19.
16. Align bumper where the bumper is spaced equally on both sides and tighten the 14mm bolts using a 22mm socket /
wrench and the factory bolts using a 18mm socket / wrench.
17. Reconnect battery cable and tighten.
PHOTO 18
INSTALL THE 14MM X 60MM BOLTS