Rough Country 257.20 - Manual (Page 10)

CAB INSTALLATION INSTRUCTIONS
1. Raise hood disconnect positive and negative battery cable from the battery using 10mm wrench. This is
done to prevent accidental airbag deployment. Check owners manual and remove airbag fuses to prevent accidental
air bag deployment.
2. Remove the eight plastic clips from the radiator bezel using a screwdriver and remove bezel. Retain hardware for
reuse. See Photo 1.
3. Remove 4 bolts from grill using a 10mm socket then pull on lower part of grill to release clips. Retain hardware for
reuse. See Photo 2.
4. Remove four of the clips from the rubber shroud that is attach to the bumper. There are 9 clips total but only 4 need
to be removed to remove bumper. Retain hardware for reuse.
5. Unplug fog lights on bumper if equipped.
6. Remove the bumper support brackets located near front body mount that attach bumper to frame using a 15mm
socket. See Photo 3. Retain hardware for reuse.
7. Remove the two upper bumper bolts using 21mm socket and remove bumper from truck. See Photo 4.
8. Remove ground wire from firewall using 10mm socket. Retain hardware for reuse. See Photo 5.
9. Remove both ground wires from frame located on front body mount using 10mm socket / wrench. Retain hardware
for reuse. See Photo 6.
PHOTO 1 PHOTO 2
PHOTO 3 PHOTO 4
PHOTO 5 PHOTO 6
REMOVE BUMPER BRACKETS REMOVE BUMPER BOLTS
REMOVE GROUND FROM FIREWALL REMOVE GROUND FROM FRAME