Rough Country 257.20 User Manual
Page 18
8. With bumper still removed, use the supplied template to mark and drill the new holes in the frame. See Photo 13.
9. Drill the holes using a 1/2” drill bit. See Photo 14.
10. Reinstall the stock 10mm bolt using the supplied 10mm lock nut back in the frame. Tighten using a 15mm and 17mm
wrench. See Photo 15.
11. Mark and cut the outer mount off of the bumper as shown. Clean and paint the area to prevent rust. See Photo 16.
12. Photo 17 shows the placement of the hitch pucks with
the 9/16” ID holes with the bumper not yet installed. This
is just to give you an ideas as to where the pucks will be
installed.
PHOTO 13
MARK HOLES USING TEMPLATE
DRILL USING A 1/2” DRILL BIT
PHOTO 14
REINSTALL THE 10MM STOCK BOLT
PHOTO 15
PHOTO 16
PHOTO 17
CUT THE REAR BUMPER MOUNT
PHOTO10 SHOWS PUCK LOCATION
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)