Rough Country 257.20 - Manual (Page 14)

31. Find the tab on driver side body mount where the emergency brake cable runs beside it and bend it up flat with
frame to gain slack for cable. See Photo 25.
32. Run cable back in its original location and reconnect to rear part of cable. See Photo 26.
33. Step 33 and 34 are only used on standard cab trucks, attach the factory strap to the bracket with stock bolt and rub-
ber washer and the supplied 12mm flange locknut. Tighten with a 18mm socket and 19mm wrench.
34. Using the supplied 12mm x 35mm long bolt and washer attach the bracket to the factory frame hole. Tighten with a
18mm socket. See Photo 27
35. Remove the two bolts from driver and pass front bumper brackets using 21mm socket. See Photo 28. Retain stock
hardware.
36. Mark the front tow hooks as driver and passenger top and remove hardware using 18mm socket. See Photo 29.
Retain stock hardware.
37. Measure 1-7/16” down from second bumper mounting hole and mark. See Photo 30. Drill using a 1/2 drill bit.
Spray some paint on new hole. Do the same for other side.
PHOTO 25 PHOTO 26
PHOTO 28
PHOTO 29
BEND TAB UP FOR CLEARANCE INSTALL E-BRAKE CABLE
REMOVE THE TOW HOOKS
REMOVE THE BUMPER BRACKETS
MARK HOLE TO BE DRILLED
USE SUPPLIED 12MM BOLT FOR FRAME SIDE
PHOTO 30
PHOTO 27