Rough Country 257.20 User Manual
Page 16
1. Unplug the license plate light connector and if equipped the trailer wiring connector. See Photo 1 & 2.
2. Remove the 3 bolts from the driver and passenger side frame as shown in Photo 3 (Driver Side Shown) that mount
the bumper to frame. These six bolts ( three per side) are removed using a 18mm and 15mm socket / wrench. Re-
tain the stock hardware.
3. Using a 21mm socket remove the 4 bolts located in the receiver hitch. See Photo 4 & 5.
4. Remove bumper and set aside.
BED INSTALLATION INSTRUCTIONS
PHOTO 1
PHOTO 2
PHOTO 3
PHOTO 4
PHOTO 5
UMPLUG HARNESS
UNPLUG HARNESS
REMOVE BUMPER BOLTS
REMOVE HITCH BOLTS
REMOVE HITCH BOLTS
See also other documents in the category Rough Country For the car:
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)