Rough Country 291.20 - Manual (Page 7)

16. Remove the lower control arm using a 18mm wrench and a 24mm socket.
See Photo 12.
17. Make sure the steering wheel is straight, mark the intermediate shaft and the rack and pinion as shown in
Photo 13.
18. Using a 11mm socket, remove the bolt in the intermediate shaft.
See Photo 14.
19. Support the rack and pinion with a jack and take good care not to hit or drop the rack. Use a 24mm socket and a 18mm
socket to remove the bolts from the rack and pinion. Carefully lower rack and pinion down making sure no wires are in
harms way. Place the rack and pinion in a safe secure area.
See Photo 15.
20. Using a 18mm wrench and socket remove the factory lower rear cross-member.
See Photo 16.
21. Using a 11mm socket remove the driveshaft from the front diff .
See Photo 17. Unplug the actuator wire from diff. re-
move wire loom from diff. remove vent tube from diff.
Photo 12 Photo 13
Photo 14 Photo 15
Photo 16 Photo 17