Rough Country 291.20 - Manual (Page 14)

12. Install shock absorbers #658727 in the factory location
tighten using a 21mm wrench.
See Photo 6.
13. Using WD-40 lubricate the ABS wire and slide the rubber
sleeve up to allow the wire to be reinstalled in the clip on
the frame. The connector will not be reattached to the
top of the frame. Reroute the lines as needed to gain
sufficient slack.
14. Re-install tires and wheels.
15. Remove jack stands and lower vehicle to ground.
16. Place shock decals on shock absorbers and window de-
cal on vehicle.
POST INSTALLATION INSTRUCTIONS
1. Check all fasteners for proper torque. Check to ensure for adequate clearance between all rotating, mobile, fixed, and
heated members. Verify clearance between exhaust and brake lines, fuel lines, fuel tank, floor boards and wiring har-
ness. Check steering gear for clearance. Test and inspect brake system.
2. Perform steering sweep to ensure front brake hoses have adequate slack and do not contact any rotating, mobile or
heated members. Inspect rear brake hoses at full extension for adequate slack. Failure to perform hose check/ replace-
ment may result in component failure.
3. On some vehicles the front lower skirting will need to be trimmed if using certain wheel /tire combinations and with
heavy offset wheels. Trim only as needed.
4. Activate four wheel drive system and check front hubs for engagement.
5. Have a qualified alignment center align the vehicle immediately. Realign to factory specifications. The following are the
recommended specifications:
Caster in degrees 4.5 +-1.0
Camber in degrees 0.0 —.3
Toe In in degrees 0.1 +-.2
6. Perform head light check and adjustment to proper settings.
7. Check and retighten wheels at 50 miles and again at 500 miles.
8. All kit components must be retightened at 500 miles and then every three thousand miles after installation. Periodically
check all hardware for tightness.
9. Install “Warning to Driver” decal on sun visor
Note: Installation of larger tires will require speedometer recalibration.
Thank you for choosing Rough Country for all of your suspension needs.
Photo 6