Rough Country 1049 - Manual (Page 7)

35. Reinstall lower radiator side brackets with stock bolts that were removed in Step 11 & 12. See Photo 31. Tighten
using a 15mm wrench.
36. Reinstall bumper using stock push pins. Two pins up top and three across bottom. With the inner fender well on the
out side of bumper install the supplied push pins into bumper. See Photo 32.
37. Reinstall grill and the four screws that were removed previously.
PHOTO 31 PHOTO 32
REINSTALL RADIATOR SUPPORTS REINSTALL INNER FENDER
93-95 YEAR MODEL BUMPER TRIMMING INSTRUCTIONS
1. Remove the foam from the bumper. Measure 1/2” up and mark from raised Location on the passenger side to the
raised location diver side. Cut from outside to outside of each location. See Photo 1.
2. Measure over from the driver and passenger raised location and mark. See Photo 2.
3. Measure down from the first cut 3” and mark. See Photo 3.
4. Cut the bumper cover using a cut off wheel or reciprocating
saw.
5. Reinstall on the vehicle with the factory hardware.
6. Install the winch per the winch installation instructions.
MEASURE 1/2” UP FROM RAISED LOCATION MEASURE OVER 1 1/2” AND MARK
PHOTO 1 PHOTO 2
MEASURE DOWN 3” AND MARK
PHOTO 3