Rough Country 1049 User Manual
Page 6
28. Remove tape that is going across bumper and measure 1/4” down as shown in Photo 25 from cut and mark it. Cut
the 1/4” from the bumper and remove.
29. Remove that piece of tape then measure 1 1/4” over from both sides of the raised locations in bumper and mark.
See Photo 26.
30. Measure 2” down from cut area and mark. See Photo 27.
31. Cut this area off be sure to cut on the correct side of tape or line and remove. See Photo 28.
32. Remove tape and test fit bumper on the new winch plate and trim any areas as necessary.
33. Install your winch. Route the winch power wires through the hole under and behind the passenger side headlight and
to the battery. See Photo 29.
34. Reinstall horn assembly using stock bolt. Use a 13mm to tighten. See Photo 30.
PHOTO 25
PHOTO 26
1 1/4”
PHOTO 27
PHOTO 28
PHOTO 29
2”
1/4”
PHOTO 30
ROUTE POWER CABLES AS SHOWN
REINSTALL HORN ASSEMBLY
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)