Rough Country 1049 - Manual (Page 4)

17. Install winch bracket inside frame as shown in Photo 13 then install outer winch support bracket on outside of frame
using the supplied 12mm x 35mm bolts / washers on side.
18. Reinstall lower radiator bezel to the new frame brackets and secure with the supplied 10mmx 1.5 bolts / washers.
See Photo 15.
19. Use a 17mm and 19mm socket to start bolts do not tighten at this time
20. Install winch plate using the supplied 9/16-1 1/2” bolts and nuts. See Photo 16. Use a 17mm and 19mm to tighten
winch mounting bracket bolts first then a 22mm socket for winch plate bolts.
21. With bumper removed from jeep remove the two clips as shown in Photo 17 and then remove styrofoam from the
bumper as shown in Photo 18. The styrofoam will not be used.
22. Please read steps 23-32 for 96-98 ZJ and make sure to understand all cuts before performing any bumper
cutting or modification. Instructions for cutting 93-95 ZJ bumper follow these instructions.
PHOTO 13 PHOTO 14
PHOTO 15 PHOTO 16
PHOTO 17 PHOTO 18
INSTALL PLATE BRACKET IN CUT FRAME INSTALL SIDE PLATE AND ALIGN HOLES
INSTALL SUPPLIED HARDWARE INSTALL WINCH PLATE
REMOVE BUMPER STYROFOAM HARDWARE REMOVE STYROFOAM AND DISCARD