Rough Country 1049 - Manual (Page 5)

23. Measure 8” from the step on top of bumper on both sides and mark it. See Photo 19.
24. Using tape, place a piece straight up with body line on outside of raised part of bumper on both sides. See Photo
20.
25. Measure between both pieces of tape it should be about 37 “. See Photo 21.
26. Measure a 1/2“ down from top of bumper. See Photo 22. Place tape even across to both pieces of tape placed on
the bumper in the previous steps.
27. Cut bumper using cut off wheel or body saw be sure to cut on the outside as shown in Photo 23 of the tape toward
the outer edge of the bumper. Also cut across from outside of piece of tape to outside piece as shown in Photo 24.
8” 8”
PHOTO 19 PHOTO 20
PHOTO 21
37”
PHOTO 22
PHOTO 23 PHOTO 24
CUT LINE
Cut Here
1/2”