Rough Country 243.20 - Manual (Page 8)

21. To remove the diff use a 7mm socket remove bolt from bracket holding the 4x4 light wire to diff. Unplug 4x4 light
wire from diff. remove driveshaft using 11mm socket. See Photo 19.
22. Cut the rear lower dif mount out using a sawzall. See Photo 20.
23. Remove the two passenger side nuts from diff using a 18mm socket. Remove the lower diff bole using 18mm
wrench and socket. See Photo 21.
24. There's a hole in the frame to access the nut for the upper diff mount. Support diff and use a 18mm wrench and
socket to remove upper diff bolt. Then remove the diff. See Photo 22.
25. Remove both bumper stops from frame using 13mm socket
26. Using a sawzall cut the upper control arm pocket one inch up from bottom on the rear of the front control arm pocket
a shown. See Photo 23.
27. Cut the upper control arm bump stop bracket off of rear control arm pocket. See Photo 24.
Photo 19 Photo 20
Photo 21 Photo 22
Photo 23 Photo 24