Rough Country 243.20 - Manual (Page 17)

8. Install lower shock bracket to the new spring perch block using the supplied 3/8” x 1.25 bolts ,washer, and nuts.
Tighten with 14mm socket and wrench. Flip shock bracket for other side. Shock bracket will point to the inside of
truck. See Photo 7.
9. Reinstall leaf spring so that it is on top of axle. Use stock hardware. With two C-clamp remove the center pin and flip
it. Use a pair of vise grips with a 15 mm socket or wrench. See Photo 8.
10. Install new spring perch block onto axle. Lower axle onto block. Install the U-bolt top plate on to leaf spring with the
short side to the back and install the U-bolts. Install the new lower U-bolt plate using the supplied 9/16” nuts and
washers. Tighten using a 22mm socket. See Photo 9 & 10.
11. Install new brake line bracket using the 5/16” self-tapper use a13mm socket do not tighten all the way. Place the
brake line into bracket and use stock clip to secure. Make sure brake lines are not in harms way. See Photo 11.
12. Install new shock using stock hardware up top and the supplied 1/2” x 2.5” bolt, washer, and nut for lower. Use a
13mm socket for upper bolts and a 19mm socket and wrench for bottom. See Photo 12.
Photo 7 Photo 8
Photo 9 Photo 10
Photo 11 Photo 12