Rough Country 243.20 - Manual (Page 15)

55. Install transfer case skid plate if equipped with stock hardware.
56. Using a 9/16 line wrench and a 5/8 wrench remove the rubber brake line from the hard line. Take care when doing
this the line maybe brittle. Install the new brake line ext. to rubber line first using two 5/8 wrenches to tighten. Note
97 and down models use the 3/8”-24 fitting lines and the 98-up models use the 7/16”-24 fitting lines. Then brake line
ext. to hard line using 9/16 line wrench and a 3/4 wrench. See Photo 61. (Note wrench size may be different on
some year models)
57. Install new brake line bracket to the stock brake line bracket using the 5/16” x 1” bolt, washer, and nut. Tighten using
a 13mm wrench. Attach the new brake line bracket to frame using stock hardware and a 13mm wrench to tighten.
Reinstall ABS wire and brake line to upper control arm with stock hardware using 13mm wrench and 10mm wrench.
See Photo 62. Make sure lines are out of harm way. Bleed the brakes and check for leaks.
58. Reinstall battery tray using stock hardware and a 13mm socket to tighten. Install battery and battery holder use a
13mm socket to tighten. Reinstall battery cable using a 8mm wrench. Reinstall grill if it was removed.
59. Install the front tires and wheels and remove truck from jack stands.
Photo 61 Photo 62