Rough Country 576.20 - Manual (Page 8)

31. Raise the differential into position with a floor jack and install using the new 12mm x 100mm bolt on the passenger
side. Do not install nut at this time. On the driver side make sure differential clears the rear lower control arm pocket
that was cut. Trim if necessary and install the supplied 12mm x 90mm bolts back to front. See Photo 25.
32. Install passenger side support bracket to rack and pinion bolt to passenger side differential bolt. See Photo 26.
33. Install rear cross-member using factory bolts and install differential bolt with new 12mm nut shown in Photo 27. It
may ease installation to tape the nut to the wrench to install on bolt.
34. At this time tighten rack and pinion bolts using a 24mm wrench. Then tighten the rack and pinion mounting plates
using 18mm wrench and tighten the upper differential bolts using a 15mm wrench and tighten the lower differential
bolts using a 18mm and 19mm wrench. See Photo 28.
35. Install front cross-member using factory hardware. See Photo 29. Do not tighten at this time.
36. Install lower control arms using the supplied 18mm x 150mm cam bolts, washers and nuts so the offset washer rests
in the tabs on the front and rear cross-members. See Photo 30.
PHOTO 25 PHOTO 26
PHOTO 27 PHOTO 28
PHOTO 29 PHOTO 30
Stock Bolt
New 12mm nut