Rough Country 576.20 - Manual (Page 5)

10. Remove the knuckle from the vehicle. Be sure not to overextend or pull out the CV axle shaft.
11. Repeat steps 4-10 for opposite side of the vehicle.
12. Remove the upper strut mounting nuts as shown in Photo 7 using a 15mm wrench and retain the nuts for reuse.
13. Remove the lower strut mount bolt from the lower control arm using a 30mm socket and 1 1/16” wrench as shown in
Photo 8 and remove the strut from the vehicle.
14. Remove the axle shaft bolts using a 12mm 12point socket as shown in Photo 9 and remove the axle shaft. Retain
the hardware for reuse.
15. Remove the nut from the sway bar link using a 21mm wrench and retain the factory nut. It may be necessary to use
a hammer as shown in Photo 10 to separate the sway bar link from the sway bar.
16. Remove the bolts on the lower control arm using a 21mm and a 1 1/16” wrench and remove the lower control arm.
17. Repeat steps 12-16 for the opposite side.
18. Remove the center cross-member bolts as shown in Photo 11 using a 18mm and a 13mm wrench. Remove the
cross-member as shown in Photo 12.
PHOTO 7 PHOTO 8
PHOTO 11 PHOTO 12
PHOTO 9 PHOTO 10