Rough Country 576.20 - Manual (Page 6)

19. Remove the sway bar as shown in Photo 13 using a 15mm socket. Set sway bar aside and retain hardware for re-
use.
20. Remove the drive shaft bolts using a 12mm 12point socket. Secure driveshaft out of harms way.
21. On the driver side. Remove the upper differential bolt as shown in Photo 14 using a 15mm socket. Retain for reuse.
It may be necessary to slightly turn the steering wheel to allow the bolt to clear the steering assembly.
22. Loosen the rear driver side bolt and the passenger side bolt on the differential using a 15mm wrench. Photo 15 and
16.
23. Place a floor jack under the front differential and remove both bolts and set differential aside.
24. On driver side stock frame; measure over 1 1/8” from hole as shown and 3 1/2” from the bottom up. See Photo 17.
Mark the area and cut using a reciprocating saw. Paint cut area to prevent rusting. Using supplied drilling template
(next to last page), mark and drill using a 17/32” bit. See Photo 18.
PHOTO 13 PHOTO 14
PHOTO 16 PHOTO 15
PHOTO 17 PHOTO 18
Cut line
1 1/8”