beautypg.com

Rough Country 576.20 User Manual

Page 16

background image

THANK YOU FOR CHOOSING ROUGH COUNTRY FOR YOUR SUSPENSION NEEDS

POST INSTALLATION INSTRUCTIONS

1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile,

fixed and heated members. Check steering gear for interference and proper working order. Test brake system

2. Perform steering sweep. Check to ensure brake hoses have sufficient slack and will not contact rotating, mobile, or

fixed members, adjust lines/brackets to eliminate interference and maintain proper working order. Failure to perform
inspections may result in component failure

3. Readjust headlights to factory settings

4. Have vehicle aligned by a certified alignment professional.
5. Re-torque all nuts, bolts, and especially u-bolts after the first 100 miles, again after another 100 miles and then check

periodically thereafter

6. All components must be retightened after 500 miles, and every three thousand miles after installation.
7. Rough Country recommends not operating the vehicle in 4 wheel drive above 40 mph. Doing so may result in a low

frequency front driveshaft vibration. If vibration does occur please refer to included instructions in this sheet to re-
clock the driveshaft.