VEGA TH LINK Version 1.1 Installation Guide - Manual (Page 23)

Configuring the TH LINK in the Ethernet network
TH LINK | Trebing & Himstedt Prozeßautomation GmbH & Co. KG
23
Setting new IP and network addresses
1. Change the Configuration method from DHCP to
Manual
(see figure 5).
Fig. 5: Setting IP and network addresses
2. Enter the new IP address.
3. Enter the new addresses for Subnet mask and Default
gateway
.
Note!
Note down the set IP address. You can only
access the TH LINK by using this IP address.