VEGA TH LINK Version 1.1 Installation Guide - Manual (Page 21)

Configuring the TH LINK in the Ethernet network
TH LINK | Trebing & Himstedt Prozeßautomation GmbH & Co. KG
21
Configuration method (DHCP/Manual)
There are two connecting options to choose from, depending on
your network:
– Connection in an Ethernet network with DHCP server –
automatic and dynamic allocation of IP addresses (connection
with patch cable via hub or switch)
– Connection in an Ethernet network with manual IP address
assignment (peer-to-peer) – manual allocation of IP addresses
(connection with crossover cable)
Connection in a network with DHCP
(Dynamic Host Configuration Protocol)
The TH LINK is preset to network operation with a DHCP server
and in this case it is automatically assigned an IP address.
Therefore, no further configuration settings are necessary.
Note!
If you connect to Ethernet network with the
power supply already connected, the DHCP
may fail to be identified. The routine for the
DHCP identification only runs during TH LINK
start-up.
Briefly switch off the power supply for a new
DHCP identification.