VEGA PLICSCOM - Manual (Page 6)

6
3 Product description
PLICSCOM •
36433-EN-130228
3 Product description
3.1 Configuration
This operating instructions manual applies to the following hardware
and software versions of the display and adjustment module:
•
Hardware from 1.0.0
•
Software from 1.0.0
The indicating/adjustment module consists of a display with full dot
matrix as well as four keys for adjustment.
An LED background lighting is integrated in the display and can be
switched on via the adjustment menu.
The display and adjustment module can be optionally equipped
with heating to ensure good readability at low temperatures down to
-40 °C (-40 °F).
The scope of delivery encompasses:
•
Display and adjustment module
•
Documentation
– this operating instructions manual
– Supplementary instructions manual 31708 "Heating for display
and adjustment module" (optional)
3.2 Principle of operation
The display and adjustment module is used for measured value indi-
cation, adjustment and diagnosis for the following VEGA sensors:
•
VEGAPULS series 60
•
VEGAFLEX series 60 and 80
•
VEGASON series 60
•
VEGABAR series 50 and 60
•
VEGACAL series 60
•
PROTRAC series 30
The display and adjustment module is mounted in the respective sen-
sor housing. With instruments with double chamber housing, the dis-
play and adjustment module can be mounted either in the electronics
or in the connection compartment.
Sensors with hardware version < 2.0.0, software version < 3.99
With Exd as well as four-wire instruments, the installation is only pos-
sible in the electronics compartment.
Radar sensors with hardware version ≥ 2.0.0, software version
≥ 4.0.0
With Exd instruments, the installation is only possible in the electron-
ics compartment.
Scope of this operating
instructions manual
Instrument versions
Scope of delivery
Application area
Installation in the sensor
housing