4 prepare setup, 1 insert display and adjustment module – VEGA PLICSCOM User Manual

Page 11

Text mode
Original mode

4 Prepare setup

PLICSCOM •

36433-EN-130228

4 Prepare setup

4.1 Insert display and adjustment module

The display and adjustment module can be inserted into the sensor

and removed any time. Four positions displaced by 90° can be se-

lected. It is not necessary to interrupt the power supply.
Proceed as follows:
1. Unscrew the housing cover
2. Place the display and adjustment module in the requested posi-

tion onto the electronics and turn to the right until it snaps in

3. Screw housing cover with inspection window tightly back on
Removal is carried out in reverse order.
The display and adjustment module is powered by the sensor, an ad-

ditional connection is not necessary.

Fig. 6: Insertion of the display and adjustment module with single chamber

housing into the electronics compartment