VEGA VEGAMET 515 - Manual (Page 13)

VEGAMET 515 13
4 Adjustment
4.1 Indicating and adjustment ele-
ments
A rotary switch is located on the circuit
board. It is used for adjustment of the instru-
ment address on DISBUS. This setting is
necessary if the measured values are to be
transmitted via the DISBUS cable to external
instruments, e.g. to VEGADIS 174 indicating
instrument, VEGACOM 557 interface con-
verter or other VEGAMETs. With these exter-
nal instruments, the allocation of a received
measured value to a specific measurement
loop can be determined by means of the
address.
The adjustment range 1 … F corresponds to
the DISBUS addresses 1 … 15.
Factory setting: 1
Note:
With address 0, the VEGAMET does not
participate in the DISBUS communication.
Rotary switch
Adjustment
The set instrument address on the DISBUS
can be indicated on the LC display.
Note
If several VEGAMET are linked via the
DISBUS, each address must only be as-
signed once!
8
7
6
5
4
0
F
E
D
C
B
A
9
3 3
2
1
10
11
12
13
14
15
Front plate VEGAMET 515
without adjustment with adjustment
module module
1 LCD (4 lines with 6 figures each, illuminated) for clear text
indication
2 LED chain (yellow) for quasi-analogue indication of the
measured value
3 Keys for menu adjustment
4 Connection socket for VEGACONNECT
5 LED (yellow) lights if the relay is energised (standard
setting)
6 LED (red), lights if fail safe relay is deenergised
7 LED (green), lights if operating voltage is on
Rotary switch
CONNECT
%
100
+ -
OK ESC
on
1 2
514
CONNECT
%
100
+ -
OK ESC
on
1 2
515V
CONNECT
on
1 2
515V
1
2
3 3
4
5
6
7
Position of the rotary switch