VTech IS7121_-2-22 Manual - Manual (Page 94)

Appendix
89
No battery The handset in the telephone base or charger has no
battery installed.
No line There is no telephone line connection.
No PTT call The incoming PTT function is disabled. The handset will not
receive PTT calls.
Not available
at this time
Someone else is using the directory, caller ID log, or answering
system.
Number
already saved The telephone number you have entered is already in the
directory.
Out of range
OR
No power at
base
The telephone base has lost power, or the handset is out of range.
Place in charger The battery is very low. Put the handset in the telephone base for
recharging.
PTT From HANDSET X
To HANDSET Y
One handset has started a PTT session to another handset.
PTT To HANDSET X You have started the PTT process.
Push to talk Ended The PTT session is ended.
Rec mem full The system recording time is full.
Registration failed The handset fails to register to the telephone base.
Ringer muted The ringer is off temporarily during an incoming call.
Ringer off The ringer is turned off.
Saved Your selection has been saved.
Speaker The speakerphone is in use.
Unable to call.
Try again.
The handset is out of range while on a call.
Failed phone call (the telephone line is in use).
Failed intercom or conference call (there are already two handsets
being used).
Unable to save You tried to save a caller ID entry with no caller ID information.
XX Missed calls There are new calls in the caller ID log.
XX new messages There are new messages in the answering system.
XXX new pics There are new photos in the photo log.
** Paging ** The telephone base is paging the handset.
Screen messages