VTech IS7121_-2-22 Manual - Manual (Page 8)

Getting started
3
Handset battery installation
Install the battery as shown below.
If the handset will not be used for a long time, disconnect and remove the battery to
prevent possible leakage.
To purchase replacement batteries, visit our website at
www.vtechphones.com
or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or dial
1 (800) 267-7377.
•
•
Insert the battery connector securely
into the socket, matching the
orientation of the engraved label.
1. Place the battery with the label
THIS SIDE UP facing up and the wires
inside the battery compartment.
2.
Align the cover flat against the
battery compartment, then slide it
towards the center of the handset
until it clicks into place.
3. Charge the handset by placing it in
the telephone base or charger. The
CHARGE light is on when the handset
is charging.
4.
Batter
y P ack
B T164392/B
T264392
2.4V 550mAh Ni-M
H
W A RNING : DO NO
T BURN OR
PUNC
TU R E B A TTERIES
Made in China CR1222
Batter
y Pa
ck / Bloc
-piles
:
(2.4V Ni-MH
)
W
ARNING /
A V ERTISSEMENT
:
DO NO
T BURN OR PUNC
TU
R E B A TTERIES.
NE P
AS INCINÉRER OU PERCER LES PILES.
Made in China / F
abriqué en chine
TH
IS
S
ID
E
U
P
/ C
E
CÔ
TÉ
V
ER
S
LE
H
A
U
T
CR1232
Batter
y P
ack / Bloc
-piles
:
(2.4V Ni-MH)
W ARNING /
A V ERTISSEMENT
:
DO NO
T BURN OR PUNC
TU
R E B A TTERIES.
NE P
AS INCINÉRER OU PERCER LES PILES.
Made in China /
Fa
briqué en chine
TH
IS
S
ID
E
U
P
/ C
E
CÔ
TÉ
V
ER
S
LE
H
A
U
T
CR1232
CHARGE light
remains on
when charging.
IMPORTANT:
Check for a dial tone by pressing . If you hear a dial tone, the installation is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to digital service
from a cable company or a VoIP service provider, the telephone line may need to be rewired
to allow all existing telephone jacks to work. Contact your cable/VoIP service provider for
more information.
•
•