VTech IS7121_-2-22 Manual - Manual (Page 60)

55
Multiple handset use
PTT to a single handset
You have two ways to begin a PTT call:
If your system has two handsets, press and hold PUSH TO
TALK when the handset is not in use.
If your system has more than two handsets, press
PUSH
TO TALK when the handset is not in use. Then use
the dialing keys to enter a handset number ( 1 to 9 for
HANDSET 1 to HANDSET 9, and 0 for HANDSET
10, or and for All handsets), or press q or p to
scroll to the desired handset then press SELECT .
Your handset displays Connecting to HANDSET X... for a
few seconds. When the connection is made, both your and the
destination handsets display Press and hold [PTT] to talk
and beep once.
Press and hold
PUSH TO TALK on your handset. A chirp
indicates your microphone is on. Speak towards the handset.
Your voice is broadcast to the destination handset. While you
are speaking, the handset displays PTT To HANDSET X
( X represents the destination handset number).
Release PUSH TO TALK after speaking. All handsets beep
once again. After the handsets beep, you can press and hold
PUSH TO TALK to continue speaking or the destination
handsets can respond (see Answer a PTT call on page 57).
Press OFF or END to end the PTT call. The handset displays
Push to talk Ended for a few seconds.
-OR-
Place the handset in the telephone base or charger to end the
PTT call.
After PUSH TO TALK is released, the PTT call remains open
for a short time. If no one presses PUSH TO TALK within
10 seconds, the PTT call ends automatically.
1.
•
•
2.
3.
4.
•
Connecting to
HANDSET 1
...
END
PUSH TO TALK
HANDSET 1
HANDSET 2
All handsets
PTT On/Off
BACK SELECT
HANDSET 1
Press and hold
[PTT] to talk
END INTCOM
Push to talk
Ended
1:35am 8/20