Veris Industries TI SERIES Install - Manual

Installation Guide
Temperature
Z204566-0G Page 1 of 3 ©2013 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 08131
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
TM
NOTICE
• This product is not intended for life or safety applications.
• Do not install this product in hazardous or classified locations.
• Read and understand the instructions before installing
this product.
• Turn off all power supplying equipment before working on it.
• The installer is responsible for conformance to all applicable codes.
No responsibility is assumed by Veris Industries for any consequences arising out of the
use of this material.
Product Identification
Product Overview
TI Series immersion temperature sensors are encased in a corrosion-resistant stainless steel housing with three
installation choices: service entry body (TIG), threaded NPT (TIH), or indoor junction box (TIW, TID). A variety of
probe lengths and RTD/thermistor options offer application flexibility. All TI Series sensors are warranted for a
period of five years.
TI Series
Immersion Temperature Sensors
TIG
TIH
TID
TIW
Thermowell
Sensor
Type
T I
Immersion Probe
Length “L”
0 = None
1 = Add Thermowell A = 2 ½" (64 mm)
B = 4" (102 mm)
C = 6" (152 mm)
D = 8" (203 mm)
E = 12” (305 mm)
Cal Certificate
Enclosure
D = Duct
G = Service Entry Body
H = Threaded NPT Only
W = Water resistant
housing
Threads
Blank = NPT
A = BSPT
B = DIN 2999
Thermowell Sizing
Probe Length Thermowell Length
A 2½" (64 mm) 1 ½” (38 mm)
B 4" (102 mm) 3” (76 mm)
C 6" (152 mm) 5” (127 mm)
D 8" (203 mm) 7” (178 mm)
E 12” (305 mm) 11” (279 mm)
0 = None
1 = 1 point Cal validation
2 = 2 point Cal validation
Options
B = 100R platinum, RTD
C = 1k platinum, RTD
D = 10k T2, Thermistor
E = 2.2k, Thermistor
F = 3k, Thermistor
G = 10k CPC, Thermistor
H = 10k T3, Thermistor
I = 1k Balco (Nickel-iron) RTD
J = 10k Dale, Thermistor
K = 10k w/11k shunt, Thermistor
M = 20k NTC, Thermistor
N = 1800 ohm, Thermistor
R = 10k US, Thermistor
S = 10k 3A221, Thermistor
T = 100k, Thermistor
U = 20k “D”, Thermistor
W = 10k T2 high accuracy, Thermistor
Y = 10k T3 high accuracy, Thermistor
Z = 10k E1, Thermistor
CC = 15k, Thermistor