TROY Group MICR_IRD M600 Security Printing Solutions series User’s Guide - Manual (Page 159)

Appendix B Duplexer Installation
Security Printing Solutions User’s Guide -- 50-70537-001 Rev. B
B-1
Installing the
Duplexer 1. Switch the printer power OFF, and then disconnect the printer power cord and data cable from the printer.
2. Remove the plastic tray cover from the rear of the printer by gently pulling it away from the printer. The
cover should easily unsnap from the printer. Store the plastic tray cover in a safe place for future use.
3. Unpack the duplexer and remove any packing materials attached to the duplexer.
4. Carefully slide the duplexer unit into the printer (see figure below) until it is firmly seated into position.
5. Reconnect the printer power cord and data cables.
6. Switch the printer power ON and allow the printer
to initialize. When the printer displays the
message,
TROY EX READY , the printer is ready for
normal operation.
7. From the printer control panel, press the
Menu button.
8. Press the down arrow ▼ to select Configure
Device, and then press the OK button.
9. Press the down arrow ▼ to select the Printing
submenu, and then press the OK button.
10. Press the down arrow ▼ to select Duplexer, and
then press the OK button.
11. Press the down arrow ▼ to select ON, and then press the OK button.
NOTE: Some items in the Printing submenu are also available in the printer driver. Printer driver settings override
control panel settings. In general, it is better to change these settings in the printer driver, if applicable.
NOTE: If assistance is required, call TROY Technical Support at (800) 332-6427, Monday through Friday, 8:00 AM to
8:00 PM, Eastern Standard Time. Customers outside the United States, please call (304) 232-0899.