Spicer DRIVELINE COMPONENTS CATALOG SLIP YOKE ASSEMBLIES - Manual (Page 2)

Important: See Safety Information in General Information Section (J300P-GI)
J300P-3
Important: See Safety Information in General Information Section (J300P-GI)
2
How To Use This Catalog
INCLUDED IN THIS CATALOG
Driveshaft Style slip yokes - page 3, Slip Flange- page 13, Splined Sleeves - page 14, Hex, Square
and Round Hole- page 16, Transmission-type - page 17,
HOW TO IDENTIFY A PART USING THIS CATALOG
To identify any slip yoke, four pieces of information are required:
1. Determine Series
2. Determine spline O.D.
3. Determine number of teeth
4. Determine length - centerline to end/ face to end / end of spline to weld
5. Determine hub diameter (if a transmission-type slip yoke)
1100 SERIES E-2.656 D-.938 USE KIT 5-101X & 5-111X
Series and all pertinent series dimensions appear as shown in the sample below:
Spline O.D. and number of teeth are found at the beginning of each data section--
1.062-16 Spline
Individual part data is shown following the spline data heading--
2.875 .938 500174-1 D1A 1-68-14 - SR 1-3-88KX
Footnotes for parts and assemblies that are discontinued, will be discontinued or replaced upon
depletion of stock, or not sold separately, are indicated by a symbol next to the part number. Match
the symbol to the appropriate status at the bottom of the page. All other footnotes are located
immediately below the yoke dimensional data.
IMPORTANT NOTICE: The data listed herein is correct to the best of our knowledge and belief;
having been compiled from reliable and official sources of information. However, WE CANNOT
ASSUME ANY RESPONSIBILITY for possible error.