Shogun Motorsports Kawasaki Ninja 250 (08-12) Frame Slider - Manual (Page 4)

8.
Counter Shaft Cover Prep: Use several layers of masking tape to completely mask off the area on
the cover where you will be working.Tape the area where you will cut and also the sides of the
part so when you hold it with another device (such as a vise or table clamp) it doesn’t damage or
scratch the part. Tip: Some customers use two soft pieces of wood on each side of the cover
wile in the vice to prevent scratches or damage to the cover while cutting. We tend to take our
time and use a small hacksaw to make slow accurate cuts then a file to clean up the edges.
Some customers have other cutting tools such as dremel tools.
9.
Counter Shaft Cover Cut: The arrow pointing to 1 will represent the distance to cut which is 2 ½
inches. The arrow pointing to 2 represents the edge of the cut.
When your cut is finished it should look something like this.
This cut out is clearance for the rear of the left rail.