Shogun Motorsports Kawasaki Ninja 250 (08-12) Frame Slider - Manual (Page 2)

Installation Steps:
1.
Some photos in this section are used for
illustration examples only. It is up to you how you
decide to cut your motorcycles counter shaft cover to accept the frame slider rail,there are
different ways customers go through this process.
Shogun is not responsible for any part of
your motorcycle for any reason. Precisely measure location of cut and if in doubt at any point
please call us before the install process has begun. Professional installation is recommended.
Always use proper safety measures during the install of this product. Do not try to install this
product without proper tools, recently calibrated torque wrench, safety goggles and gloves.
2.
Remove left and right body panels. Unclip the turn signal connectors on each side.
3.
Remove shift linkage from shift shaft and take counter shaft cover off.
4.
Loosen front and rear engine through studs.
Do not remove studs until after step 5.