Shogun Motorsports Yamaha R1 (09-12) Frame Slider - Manual

Yamaha R1 09-12 Frame Slider Installation
Instructions
Part Numbers: 750-6749, 755-6749, 750-6740
MADE IN THE USA!
Carefully read instructions in their entirety before the install
Professional installation is recommended. Always use proper safety measures during the install of this
product. Do not try to install this product without proper tools, recently calibrated torque wrench,
correct torque specifications from factory service manual, safety goggles and gloves. The motorcycle
must be in a fixed secure position before the install process begins. DO NOT remove both engine studs
at the same time.
Shogun is not responsible for any part of your motorcycle for any reason. Precisely
measure location of cut and if in doubt at any point please call us before the install process has begun.
Replacement Parts List: Left Side Components (as if you were sitting on the bike)
QTY
Price each Part Numbers Descriptions
1
$20.00 99-FS-750-6749-L Black Left Side Puck
1 $20.00 99-FS-750-6740-L White Left Side Puck
1 $3.50 99-HB-SH12125120 Socket Cap 12 X 1.25 X 120 Main Engine Stud
Replacement Parts List: Right Side Components (as if you were sitting on the bike)
1
$20.00 99-FS-750-6749-R Black Right Side Puck
1 $20.00 99-FS-750-6749-R White Right Side Puck
1 $3.50 99-HB-SH1212580 Socket Cap 12 X 1.25 X 80 Main Engine Stud
Frame Sliders: Left and Right frame sliders are the same length.
Bolts: Left side bolt is longer than right.
Some photos in this section are used for
illustration examples only.
Installation Steps:
1.
Remove left side panel to expose mounting location.
2.
Locate the left side engine stud and remove bolt. Make sure the conical spacers stay in frame
when frame sliders are installed.