Shogun Motorsports DMP Power Grid LED Tail Light General Instructions - Manual

Power Grid LED Integrated Tail Light General Installation Instructions
Carefully read instructions in their entirety before installation.
Professional installation is recommended. Always use proper safety measures during the installation of this
product. Do not try to install this product without proper tools and factory service manual. The motorcycle must
be in a fixed secure position before the installation process begins.
Disconnect the stock battery before the start of
the installation process. DO NOT test terminals while battery is connected- this can cause damage to the tail light
and electrical system.
All DMP Power Grid LED Integrated Tail Lights are bench tested in production and once again
before being packaged. DMP is not responsible for any damage caused to the product or motorcycle by incorrect
installation. If you have any questions please call us directly.
Running Light, Brake Light and Blinker Function
The LED light unit triple wire harness plugs directly into the OEM wire harness designed for the stock tail light.
Optional integrated turn signals are designated by Yellow and Blue wires coming off of the harness connected to
the DMP LED Integrated Tail Light. If you are sitting on the bike the yellow wire connects to the right side blinker
and the blue wire connects to the left side blinker.
Installation
DMP LED Integrated Tail Lights are designed to replace the OEM factory unit with the use of OEM original
hardware. Pay close attention during the disassembly process to ensure proper assembly later. Tip: During
disassembly it might be useful to use a small digital camera or camera phone to remind the installer where things
go in conjunction with the OEM factory service manual.
Test Function
NOTE: Double check before you test the functionality of your new DMP tail light, make sure there are no crossed
or short circuited connections before you reconnect the battery. If your new DMP tail light is not operating
properly please check all your connections thoroughly.
READ CAREFULLY THIS PRODUCT IS SOLD FOR OFF ROAD USE ONLY!!!
Please check your local laws related to D.O.T. requirements for motorcycle marker and tail lights. It is the rider’s
responsibility to check the functionality of the tail light each and every time you start your motorcycle. There is no
guarantee that the use of this product can or will help prevent an accident in anyway.
Note: The DMP Power Grid LED Integrated Tail Light feature is designed to be used with stock components. Any
aftermarket LED marker lights or turn signals may disrupt the Integrated Tail Light feature. In this case, flasher
relays maybe required. DMP flasher relays can be purchased through your DMP dealer or at
www.moto911.com .
Flasher Relay part numbers and fitment:
900-5500 = Universal, Suzuki, Kawasaki Ninja 250 (08-11)
900-5515 = Honda, Yamaha and Kawasaki