Shogun Motorsports Suzuki GSXR600_750 (2008) Frame Slider - Manual

Suzuki GSXR600/750 2008 Frame Slider
Installation Instructions
Part Numbers: 750-5449, 755-5449, 750-5440
MADE IN THE USA!
Carefully read instructions in their entirety before the install
Professional installation is recommended. Always use proper safety measures during the install of this
product. Do not try to install this product without proper tools, recently calibrated torque wrench,
correct torque specifications from
factory service manual , safety goggles and gloves. The motorcycle
must be in a fixed secure position before the install process begins. DO NOT remove both engine studs
at the same time.
Shogun is not responsible for any part of your motorcycle for any reason. Precisely
measure location of cut and if in doubt at any point please call us before the install process has begun.
Replacement Parts List: Left Side Components (as if you were sitting on the bike)
QTY
Price each Part Numbers Descriptions
1
$20.00 99-FS-750-5449-L Black Left Side Puck
1 $20.00 99-FS-750-5440-L White Left Side Puck
1 $3.50 99-HB-SH101250110 Socket Cap 10 X 1.25 X 110 Main Engine Stud
Replacement Parts List: Right Side Components (as if you were sitting on the bike)
1
$20.00 99-FS-750-5449-R Black Right Side Puck
1 $20.00 99-FS-750-5440-R White Right Side Puck
1 $3.50 99-HB-SH10125080 Socket Cap 10 X 1.25 X 80 Main Engine Stud
Frame Sliders: Right shorter than Left
Some photos in this section are used for illustration examples only.
Installation Steps:
1.
There is an existing 1 inch hole in the right body panel, remove right side bolt. Mount right side
puck (shorter slider) with (99-HB-SH10125080) Socket Cap 10 X 1.25 X 80 Main Engine Stud and
torque down.