EVS XSense Version 10.03 - July 2010 Configuration Manual - Manual (Page 9)

Issue
10.03.A XSense – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
2
1. Introduction
1.1 PURPOSE AND STRUCTURE
The aim of this manual is to describe the various configuration parameters that
have to be defined when you work on a server in XSense mode.
1.2 APPLICATION SELECTION AND
CHANNEL CONFIGURATION
Prior to configuring the Multicam and server settings in the Setup Configuration
module or on the XSense Remote Panel, you must have selected the application
you will run on the server. In this step, you also define the channel configuration
to be used with the selected application, as well as several audio and video
parameters for the server.
You perform this initial step in the EVS and AVCFG software programs. The EVS
software is started when the server is switched on. For more information on this,
refer to the XT Tech Ref Software manual.
If a default application has been previously selected, this application will start
automatically after a few seconds if no key is hit.
If a default application hasn't been defined or if the space bar is hit, the system
will remain in the EVS main menu and wait for the operator's next command.