EVS XSense Version 10.03 - July 2010 Configuration Manual - Manual (Page 57)

Issue
10.03.A XSense – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
50
3.8.12 F
REEZE ON
C
UE
P
OINTS
Possible values: No (default) / Yes
The purpose of this functionality is to allow marking cue points on any field of a
record train and freeze on the cue point when the playback reaches it. This is
similar to the freeze on OUT point functionality but because it will be done on cue
point, you will be able to freeze on any field (impossible with OUT points).
When playing record trains where cue points have been marked, the playout
freezes on the cue point if the parameter is set to “Yes”. It plays through if the
parameter is set to “No”.
The Post-Roll parameter is not taken into account for this functionality.
Record Trains p.2.3
[F1]Internal Loop Mode : Video+Audio
[F2]Make Clip rem. Trains : Ctrled Cams
[Menu]Quit [Clr+F_]Dft [F9]PgUp [F0]PgDn
3.8.13 I
NTERNAL
L
OOP
M
ODE
Possible values: Video + Audio (default) / Video only
This parameter defines which components of PGM1 output must be recorded back
into the server when the Loop mode is engaged.
• Video + Audio: Both video and audio signals of PGM1 are recorded back into
CAM A input.
• Video only: Only the video signal of PGM1 is recorded back into CAM A input.
This allows the operator to continue the record of live audio tracks during the
Loop process. This can be useful to add music, voice or live sound to an edit for
example.
Note
In audio embedded, the audio is always looped, whether the loop mode
is set to video + audio or video only.
3.8.14 M
AKE
C
LIP
R
EM
. T
RAINS
Possible values: Ctrled Cams (default) / All cams
This parameter allows clipping all cameras of a remote server if at least one
record train of that server is controlled.