Audio meters adj. (db), 4 network settings, Clip edit by network – EVS XSense Version 10.03 - July 2010 Configuration Manual User Manual
Page 14: 5 clip management settings, Default copy/move, Auto name clips, Network settings, Clip management settings
XSense – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
Issue 10.3.A
A
UDIO
M
ETERS
A
DJ
.
(
D
B)
Possible range: -83.2dB to 0dB. Default: 0dB
This parameter allows adjusting the sensitivity of audio meters on the OSD of the
output monitors. A positive value means that the meters will be more sensitive.
2.2.4 N
ETWORK
S
ETTINGS
You can also define the Clip edit by network setting on page 3.1, F6 of the setup
menu on the Remote Panel. You will find a description of these settings in the
XSense operating manual.
C
LIP
E
DIT BY
N
ETWORK
Possible values: Disable (default) / Enable
If this function is enabled, other users on the network can trim, rename, delete,
etc. your clips, or modify the keywords and ranking assigned to your clips. If
disabled, only the local operators can modify or delete clips on the server and edit
their metadata.
2.2.5 C
LIP
M
ANAGEMENT
S
ETTINGS
You can also define most of the Clip management settings on pages 3.1 to 3.3 of
the setup menu on the Remote Panel. You will find a description of these settings
in the XSense operating manual.
D
EFAULT
C
OPY
/M
OVE
The Default Copy/Move parameter allows specifying whether the copy operations
should be executed preferably using the SDTI or the HCTX GigE network.
If the value selected is ‘SDTI’, the copy operations are first executed through the
SDTI network. If the SDTI network is temporarily unavailable, the transfer is then
tried through the HCTX GigE interface. Transfers to GigE targets will always be
performed via the HCTX GigE interface.
If the value selected is ‘GbE’, the copy operations are first executed via the HCTX
GigE interface. If the transfer is not possible (ports not connected, IP address
unknown, no more connection ports are available), the transfer is then tried
through SDTI.
A
UTO
N
AME
C
LIPS
Possible values: Disabled (default) / TC IN / CAM Name / ID Louth / VarID
If this function is enabled, the value of the selected field will automatically be
used to name the clip upon creation.
7