EVS GX Version 1.00 - February 2011 User’s Manual - Manual (Page 23)

GX server – Version 1.0 – User’s Manual
EVS Broadcast Equipment – February 2011
Issue 1.0.C
17
The following settings for the GX server can be defined in the Settings area of the
Server Control window:
Setting Description
Video Standard Video standard the GX server can run in.
The following standards are available:
• SD NTSC DF or SD NTSC NDF
• SD PAL
• 1080i 59.94Hz DF or 1080i 59.94Hz NDF
• 1080i 50Hz
• 720p 59.94Hz DF or 720p 59.94Hz NDF
• 720p 50Hz
Any change in the standard is immediately reflected on the
output and status screen.
When the GX server is started, only GX c lips created in the
selected video standard will be visible to the protocol
clients.
COM Port Serial port number on the VDCP controller through which the
GX server will communicate.
Protocol Protocol the GX server will use to communicate with the
controller.
The VDCP protocol is available on the current GX server
version.
VDCP Version Version of the VDCP protocol to be used in communications
between the server and the controller.
The versions available are the following: ‘2000’, ‘1998’.
Genlock Phase Phase of the genlock input on the GX server video board.
Enable OSD Tick the check box to activate the OSD (status screen) on
the SDI output of the GX server.
Advanced Options The advance options are hidden by default. They allow users
to specify which information should be included in the logs.
They should only be modified by, or in agreement with the
EVS customer support.