AASTRA 6755i User Guide EN - Manual (Page 135)

Handling Calls
41-001386-00 REV01 – 06.2013
128
Pre-Dial & Live Dial Mode
By default, when users are initiating a conference call or transfer, they will not hear a dial tone before dialing begins (pre-
dial mode). The phone does not automatically dial out the number until the user presses the “Conference” key. This allows
the users to make changes to the dialing number before initiating the call. Administrators can configure a live dial mode.
In live dial mode, when the user is completing a conference call or transfer, they will hear a dial tone before dialing begins.
In addition, the phone will either match the number to the dial plan or wait for the set digit timeout.
In the default pre-dial mode, users are able to edit the destination number prior to dialing, whereas in live dial mode they
are not able to, however the “Dial” and “Cancel” softkeys are provided while the user inputs the number.
Using Local Conferencing in Pre-Dial Mode
Use the following procedure to create a conference call using local conferencing in pre-dial mode. Use the following illus-
tration as a reference.
IP Phone UI
1. When you begin a conference, you are the first party in the conference (Party 1). Pickup the handset or press the
speakerphone key. A line opens up.
2. Call Party 2 by dialing their number (or answer an incoming call of a Party).
3. Wait for Party 2 to answer. When Party 2 answers, you can consult with them before adding them to the conference.
4. Press the Conf key. You will not hear a dial tone before the dialing begins.
5. Enter the phone number of Party 3.
Note:
Users are able to edit the destination number (“Backspace” softkey is provided and navigation key is functional to
move the cursor to the desired location).
6. Wait for Party 3 to answer. When Party 3 answers, you can consult with them before adding them to the conference.
Conference key when
handset is lifted
L1 John Doe
Dial
Backspace
1
.
4161234567
2. 4299
More
Cancel