5 environmental requirements, 1 cordless telephone, 2 battery – AASTRA DT692 Cordless for MXONE Quick Reference Guide EN User Manual
Page 11

C
ORDLESS
P
HONE
FOR
MD E
VOLUTION
11
1424-EN/LZT 103 090 Uen D 2010-02-12
2.5 Environmental
Requirements
2.5.1 Cordless
Telephone
•
Note: Do not use the cordless phone in areas with a danger of 
explosion, as it is not specified as intrinsically safe.
•
Only use the telephone in temperatures between 0
o
C to +40
o
C
(32
o
F to 104
o
F).
•
Avoid exposing the telephone for direct sunlight or close to other 
heat sources.
•
Do not expose the telephone to open flame.
•
Keep the telephone away from excessive heat and moisture.
•
Moving the equipment rapidly between warm and cold tempera-
tures may cause condensation (water droplets) to form on its 
internal and external surfaces. Water droplets may cause malfunc-
tion of the equipment and corrupt or end communication or damage 
the equipment. When condensation is noticed, stop using the 
equipment. Switch off the phone, remove the battery and unplug 
the mains adapter from the power outlet. Wait until the moisture 
evaporates from the equipment before putting it in operation again.
•
Protect your telephone from aggressive liquids and vapours.
•
If the telephone has been exposed for water or condense, remove 
the battery immediately and let it dry completely before re-inserting 
the battery.
•
Do not place a cold telephone in a charger.
•
If the liquid crystal display breaks, avoid injury by preventing the 
liquid crystal from coming into contact with eyes, skin or mouth. 
Prevent the liquid crystal from leaking out of the broken glass.
•
In case of smoke or fumes, stop operating the product and turn it 
off immediately. Unplug the mains adapter and remove the 
batteries from the phone immediately. Continued operation may 
result in fire or electrical shock.
2.5.2 Battery
•
Do not immerse the battery into water. This could short-circuit and 
damage the battery. If the battery has been exposed to water or 
condense, remove it immediately and let it dry completely before 
reinserting it.
