AASTRA 6737i User Guide EN - Manual (Page 178)

Additional Features
171
41-001452-00 Rev 01 – 06.2013
Call Waiting Tone Period
You can specify a specific time period (in seconds) for the call waiting tone to play at regular intervals on an active call
using the parameter “Call Waiting Tone Period”. A value of “0” is the default and plays the call waiting tone only once on
the active call. When the incoming caller hangs up, the call waiting tone stops on the existing active call.
You can enable or disable this feature in the Aastra Web UI.
Configuring “Call Waiting Tone Period”
Use the following procedure to configure “Call Waiting Tone Period”.
Aastra Web UI
1. Click on Basic Settings->Preferences->General.
2. In the "Call Waiting Tone Period" field, enter a time period, in seconds, that the call waiting tone will be audible on
an active call when another call comes in. Default is 0 seconds.
3. When enabled, the call waiting tone plays at regular intervals for the amount of time set for this parameter. For example,
if set to “30” the call waiting tone plays every 30 seconds. When set to “0”, the call waiting tone is audible only once
on the active call.
4. Click Save Settings.