AASTRA 6737i User Guide EN - Manual (Page 117)

Line Keys and Softkeys
41-001452-00 Rev 01 – 06.2013
110
Using the Paging Key
The following procedure describes the use of the Paging key on the IP Phone. The procedure assumes you have already
configured the Paging key using the Aastra Web UI.
6. To receive RTP steams for Group Paging, you must also configure the "Paging Listen Addresses" parameter at the
path, Basic Settings->Preferences->Group Paging RTP Settings. For more information about setting this parameter,
see
“Group RTP Paging (receives RTP streams)” on page 177 .
Expansion Module Keys
7. Select from “Key 1” through “Key 36” (M670i)
or
Select from “Key 1” through “Key 60” (M675i)
8. In the "Type" field, select Paging.
9. (M675i) In the “Label” field, enter a label to apply to this key.
10. In the “Value” field, enter a multicast IP address and a port number for the Paging key. When you press this key,
the phone initiates an outgoing multicast RTP session to the specified address using the specified port. (For exam-
ple, 239.0.1.15:10000).
Notes:
1. When you select Paging for the “Type” field, the “Line” field is disabled.
2. The “Value” field allows for one multicast address entry only.
11. To receive RTP steams for Group Paging, you must also configure the "Paging Listen Addresses" parameter at
the path, Basic Settings->Preferences->Group Paging RTP Settings. For more information about setting this param-
eter, see
“Group RTP Paging (receives RTP streams)” on page 177 .
12. Click Save Settings.
IP Phone UI
Notes:
1.Recipient of a Paging call can set a global “Do Not Disturb” (DND) to ignore any incoming pages.
2.For incoming Paging, the phone uses the Intercom configuration settings. The incoming Page is dependant on the
“Allow Barge-In” parameter setting and the “Idling/On Call” state.