American Magnetics 420 Power Supply Programmer - Manual (Page 58)

40 Rev. 7
Operation
Setup Menu : Supply
3.2.1 Supply Setup Submenu
The Supply setup submenu provides for the specification of the power
supply parameters. If you wish to set the limits of operation for a
connected magnet, refer to the current limit and the voltage limit
configurations.
If using a standard power supply supported by AMI, selecting a power
supply within the Select Power Supply menu sets all the remaining
parameters in the supply menu according to Table 3-2.
3.2.1.1 Select Power Supply
The select power supply parameter provides a selection menu that
contains presets for standard AMI power supplies. Use the
237,21
key to cycle through the list of selections. The selection becomes
effective immediately. If a supply other than Custom... is selected,
all remaining items within the Supply submenu are automatically
set and cannot be edited. The available selections and associated
supply parameters are provided in Table 3-2.
T@UVQÃH@IV
T@G@8U
QPX@SÃTVQQG`
HDIÃPVUQVU
WPGU6B@
H6YÃPVUQVU
WPGU6B@
HDIÃPVUQVU
8VSS@IU
H6YÃPVUQVU
8VSS@IU
WWÃHP9@
DIQVUÃS6IB@
TU67DGDU`
T@UUDIB
8PDGÃ8PITU6IU
@I@SB`
67TPS7@S
QS@T@IU4
9DTQG6`
8PIUS6TU
S6HQÃS6U@
UDH@ÃVIDUT
T@SD6GÃ76V9
S6U@
T@SD6GÃ96U6
7DUTQ6SDU`
GP69 HDT8 8PHH TVQQG` SUBMENUS
PARAMETERS
@I67G@ÃRV@I8C
9@U@8U4
D@@@#''
699S@TT
T@SD6G
TUPQÃ7DUT
T@SD6G
C6I9TC6FDIB
QTXDU8C
8VSS@IU
QTXDU8C
C@6U@9ÃUDH@
QTXDU8C
DITU6GG@94
Fo
r
Cu
s
to
m
..
. s
e
le
c
ti
on on
ly
8VSS@IUÃGDHDU AD@G9ÃVIDUT
Figure 3-2. Setup menu, submenus, and parameter diagram.
$ × 6HOHFW 3RZHU 6XSSO\
9V $0, 36