American Magnetics 420 Power Supply Programmer - Manual (Page 13)

Rev. 7 xi
Foreword
Purpose and Scope
This manual contains the operation and maintenance instructions for the
American Magnetics, Inc. Model 420 Digital Power Supply Programmer.
The manual outlines the instructions for instrument use in various system
configurations. Since it is not possible to cover all equipment combinations
for all magnet systems, the most common configurations are discussed and
the user is encouraged to contact an authorized AMI Technical Support
Representative for information regarding specific configurations not
explicitly covered in this manual.
Contents of This Manual
Introduction introduces the reader to the functions and characteristics of
the instrument. It provides the primary illustrations of the front and rear
panel layouts as well as documenting the performance specifications.
Operational theory is also provided in the form of circuit diagrams.
Installation describes how the instrument is unpacked and installed in
conjunction with ancillary equipment in typical superconducting magnet
systems. Block-level diagrams document the interconnects for various
system configurations.
Operation describes how the instrument is used to control a
superconducting magnet. All instrument displays and controls are
documented. The ramping functions, persistent switch heater controls,
and the quench detect features are also presented.
Remote Interface Reference documents all remote commands and
queries available through the RS-232 and IEEE-488 interfaces. A quick-
reference summary of commands is provided as well as a detailed
description of each.
Service provides guidelines to assist the user in troubleshooting possible
system and instrument malfunctions. Information for contacting AMI
Technical Support personnel is also provided.
The Appendix documents the rear panel connectors.