ACU-RITE 100S - Manual (Page 25)

22 100S General Purpose Reference Manual
Troubleshooting
Improper procedure Press the ENTER key after
each parameter value is en-
tered. If you press another
key instead, the new value
may not be saved. Refer to
pgs. 5 - 10 for proper pro-
cedures.
Setup does
not save
values
Numbers
don’t appear/
are faded on
the display LED failure Turn the system “off” and
then “on” again, using the
switch on the back of the
readout. If this does not
correct the problem,
contact your
100S GP dis-
tributor for repair/replace-
ment procedures.
Symptom Probable Cause
Recommended
Corrective Action